Lighting repairs and LED upgrades
Lights that work, look right and cost less to run, in your home, shop, restaurant or venue.
When you need it
- Lights flicker, buzz, dim or go out on their own
- An LED panel or downlight has stopped working, often because its driver has failed
- Old fluorescent tubes flicker or are slow to start, usually a failing ballast
- A lighting circuit trips the RCD or keeps blowing a fuse
- Shop window, shelf or display lighting has failed or looks patchy
- Emergency lights or exit signs show a fault, failed a test, or no longer stay on for their full rated time
- You still have halogen or fluorescent fittings and want lower running costs
What is included
- Finding why a light or lighting circuit has failed
- Replacing failed LED drivers, fluorescent ballasts, transformers, lamp holders and switches
- Swapping halogen, fluorescent and older fittings for LED
- Repairing and upgrading display, shelf and window lighting
- Repairing emergency lighting and exit signs, and replacing worn batteries and failed fittings
- Advice on brightness, colour of light and dimming, so the result suits the room
- Testing the circuit when the work is finished, with a written record of what was done
What to expect on the day
We start by finding the cause. A light that will not come on may be the lamp, the driver, the fitting, the switch or the circuit, and each needs a different fix.
Power to the lighting circuit is switched off while we work. We tell you first, and for businesses we can plan the work around your opening hours to keep disruption low.
For LED upgrades we check that new fittings suit your existing dimmers and switches. Some older dimmers need replacing too, and we tell you before we start.
Emergency light batteries usually wear out before the fittings do. If emergency fittings are converted to LED, they are tested afterwards so they still stay lit for their full rated time. If the system needs more than a repair, we explain what is required and quote first.
Questions people ask
Why did my LED light stop working when the bulb looks fine?
Many LED fittings have a separate driver that powers the light. Drivers often fail before the LEDs do, and replacing the driver can save the fitting.
Is switching to LED worth it?
LED fittings usually use much less electricity than halogen or fluorescent ones and last far longer, so they suit lights that are on for many hours a day.
Will my dimmer switches work with LED?
Not always. Older dimmers can make LEDs flicker or buzz. We check this and recommend a compatible dimmer where needed.
Can you repair emergency lighting in my business?
Yes. We find the faulty lights or batteries, repair or replace them and test the system afterwards.
Not yet reviewed by a qualified electrician.
Ask about lighting repairs and led upgrades
Tell us what is happening and we will get back to you.
Not set yet: phone number, WhatsApp number, response time, area covered. Add them in src/config/site.ts. Until then the quote form is the only contact route shown.